Hey guys… Well Ive been workin on this guy for bit and I cant quite put my finger on it but I still think it looks outta proportion.. Take a look and tell me what you think would make it look a little more in proportion.. All input is much appreciated.
Thanks
http://www.essence3d.com/cloth1.jpg
His pelvis is too stubby and his legs are too short.. thats where the porportions are off.
Try making his pelvis a tad bit higher [about 1/4] and add roughly one head length of height to the legs.
Regards,
Kurt
The classic proportions in heads are; 8 heads total height, from top; 2-nipples, 4-groin(hip joint), 6-knee joint(just below kneecap) and 8-the soles of the feet. It is somewhat simplified but it works fine. I use it all the time.
Very Cool Model… isnt that Collosus from the X-Men? If so, check out the comic for proportions… if it isnt Collosus, man, it looks like him… looking good either way.
nice stuff, don’t mind with proportions disproportion actually gives character to your characters anyway no one have the same proportions