Is there any way to find out what type a given material is through mel.
Is it Lambert, Blinn, Anisotropic, etc.....
Novy Dhillon
Radical Entertainment Inc.
Vancouver BC.
ndhillon@radical.ca
Is there any way to find out what type a given material is through mel.
Is it Lambert, Blinn, Anisotropic, etc.....
Novy Dhillon
Radical Entertainment Inc.
Vancouver BC.
ndhillon@radical.ca
ls -st blinn3;
// Result: blinn3 blinn //
BTW.. I looked into if it was possible to change the type but I did not find a way
---a note from our sponsor---
Have you tried searching highend3d?
How about:
nodeType blinn1;
// Result: blinn //
rokl
If you want to change the type of a material you can do the following:
If you don't call delete yourNode then yourNode will still exist. This way you can make a bunch of materials based on yourNode by repeatedly calling replaceMaterial.
Gordie Neill
Software Engineer
Alias|wavefront